TITLE

Analyses of mechanical characteristics of vacuum circuit breaker during the closing process taking electrodynamic force into account

AUTHOR(S)
Wang, X.; Rong, M.; Wu, Y.; Yang, F.; Jia, S.
PUB. DATE
November 2007
SOURCE
IET Science, Measurement & Technology;Nov2007, Vol. 1 Issue 6, p323
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A dynamic model for the closing process of a medium-voltage vacuum circuit breaker (MVVCB) is constructed, and the automatic dynamic analysis of mechanical system software is applied to construct the model by taking electrodynamic force into account. After the electrodynamic force is worked out, the model is employed to investigate the mechanical characteristics during the closing process of a MVVCB under the influence of electrodynamic force. The characteristics are also investigated through experiment. Moreover, the simulation and experimental results are in close agreement. The results show that the electrodynamic force not only reduces the moving speed of the main axle's angle to a certain degree but also influences the four parameters used to describe the performance of mechanical characteristics. The simulation and experimental results presented here can be used to highlight the design criteria on the optimal operation and condition monitoring of MVVCBs.
ACCESSION #
26370072

 

Related Articles

  • A Dynamic Model of Air Pollution, Health, and Population Growth Using System Dynamics: A Study on Tehran-Iran (With Computer Simulation by the Software Vensim). Shahgholian, Keyvan; Hajihosseini, Hamid // World Academy of Science, Engineering & Technology;Nov2009, Issue 35, p245 

    The significance of environmental protection is well-known in today's world. The execution of any program depends on sufficient knowledge and required familiarity with environment and its pollutants. Taking advantage of a systematic method, as a new science, in environmental planning can solve...

  • Simulation Lateral Vibrations Processes of a Passenger Wagon Body. Skvireckas, R.; Bazaras, Ž.; Markšaitis, D.; Černiauskaitė, L. // Transport Means 2007: Proceedings of the 11th International Conf;2007, p99 

    Numerical methods of investigation are used in the thesis. Theoretical investigation were performed using MSC.ADAMS/View and MSC.ADAMS/Rail software. Introduction of additional characteristics into this software enabled us both to form dynamic model of typical passenger wagon used in Lithuania,...

  • DYNAMIC MODELING OF HUMAN LUMBAR SPINE VIA MSC ADAMS. Tabesh, Majid; Elahinia, Mohammad // Conference Proceedings of the Annual Meeting of the American Soc;2010, p285 

    The article focuses on a study which presented a dynamic model of the human lumbar spine using the MSC ADAMS software. The software analyzed the load bearing properties of the spine in different conditions such as shocks induced from driving on a bump road. To capture the load pattern on the...

  • Crash testing for dummies.  // Automotive Engineer;Dec2005, Vol. 30 Issue 11, p34 

    The article the TNO Automotive Safety Solutions has launched the Mathematical Dynamic Modelling (MADYMO) /Exchange. This new software tool enables users to harness the power of some of the most effective crash test simulation software available. MADYMO software allows users to create virtual...

  • Rudder Based Roll Control via host-computer of A Robotic Boat. Xinping Bao; Zhenyu Yu; Nonam, Kenzo // International Journal of Advanced Robotic Systems;Mar2009, Vol. 6 Issue 1, p43 

    Rudder based roll control of a small-sized robotic boat is a key technique for the devices on board to achieve good performance. This paper introduces a host-based robotic boat capable of performing basic movement operations. The course keeping and roll reduction are studied via rudder based...

  • A Model for Estimating the Potential Biomagnification of Chemicals in a Generic Food Web: Preliminary Development. Alonso, Elena; Tapie, Nathalie; Budzinski, Hélëne; Leménach, Karyn; Peluhet, Laurent; Tarazona, José V. // Environmental Science & Pollution Research;Jan2008, Vol. 15 Issue 1, p31 

    The article presents a study on a conceptual method for calculating the biomagnification potential in a generic food web, which was mathematically implemented through system dynamic models created under data sheet software. Results showed that the mathematical implementation of the conceptual...

  • Dynamic models of team rowing for a virtual environment rowing training system. Filippeschi, Alessandro; Ruffaldi, Emanuele; Frisoli, Antonio; Avizzano, Carlo Alberto; Varlet, Manuel; Marin, Ludovic; Lagarde, Julien; Bardy, Benoit; Bergamasco, Massimo // International Journal of Virtual Reality;2009, Vol. 8 Issue 4, p49 

    In this paper we report on the strategies adopted to model team rowing behavior for an in-door rowing training system. This system allows athletes to train at in-door location while preserving the main features of out-door rowing. This paper focuses on the dynamic models employed to simulate...

  • Bond Graph Modeling of Inter-Actuator Interactions in a Multi-Cylinder Hydraulic System. Muvengei, Mutuku; Kihiu, John // World Academy of Science, Engineering & Technology;May2011, Issue 53, p32 

    No abstract available.

  • New approach for dynamic modelling of flexible manipulators. Bouzgarrou, B. C.; Ray, P.; Gogu, G. // Proceedings of the Institution of Mechanical Engineers -- Part K;2005, Vol. 219 Issue 3, p285 

    This paper deals with the dynamic modelling of flexible manipulators. Expressing such models analytically is extremely useful in simulation, design, control, and identification. To this end, an efficient and systematic approach is proposed for symbolic derivation of dynamic equations. A...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics